4.6.2 Assembling Long shield Option S
The reading side of the fitting is assembled on the outside of the door; the non-reading side is
assembled on the inside.
The handle set cannot be assembled on split follower locks!
Tools required:
Tool Required for Part of
the
assembly
set*
ILS spanner
(8 mm)
Fixing screws nuts
3 mm
Allen-
key
Grub screws of the inside shield lever handle, in the case of the
outer shield also for countersunk head screws of the outside shield
0.4 mm x
2.0 mm
slot head
screwdriver
Screwing the cables
CES ring
spanner
Fixture ring
“The assembly set is supplied one-off with the first order of a system. You can order
additional tools from your CES partner.
Long shield ILS Page 35 of 141
4.6 Assembly Option S (for Short shield holes)
Overview: Master media usage
Help & troubleshooting Technical data Maintenance & disposal Operation Administration
Assembly
Basics
To Next Page
Loading...
