4. Guide the CABLES through the FIXING RING.
5. Push the FIXING RING on the handle set to fix the screw
in the position that matches the existing holes.
- While doing so, hold the CABLES tight, so that they do not
get pinched or jammed.
Ensure that the cables are not jammed by the fixing
ring!
6. Insert the SQUARE SPINDLE in the coupling follower.
Make sure that the elongated hole is level.
Make sure that the ball of the square spindle in the
drill hole latched in the coupling follower.
Long shield ILS Page 37 of 141
4.6 Assembly Option S (for Short shield holes)
Overview: Master media usage
Help & troubleshooting Technical data Maintenance & disposal Operation Administration
Assembly
Basics
To Next Page
Loading...
