2. Place the ASSEMBLY PLATE on the FIXING SCREWS and press
the square hole of the INSIDE LEVER HANDLE on the SQUARE
SPINDLE.
3. Use the Allen key to screw the grub screw into the
INSIDE LEVER HANDLE, to secure the SQUARE SPINDLE.
4. Put a WASHER and a NUT on the FIXING SCREW WITH WIRING
SLIT.
While doing so, keep the cables upwards, so that
they do not get squeezed!
5. Depending upon whether the Euro Profile cylinder is
assembled or not, the spring clip will be assembled.
a) In case the Euro profile cylinder is assembled, the spring
clip will not be assembled. Put only the WASHERS and NUTS
on both of the lower FIXING SCREWS.
Page 40 of 141 Long shield ILS
4.6 Assembly Option S (for Short shield holes)
Overview: Master media usage
Help & troubleshooting Technical data
Maintenance & disposal
Operation Administration
Assembly
Basics
To Next Page
Loading...
