b) In case no Euro profile cylinder is assembled, then the
spring clip will be assembled. Put the SPRING CLIPS, WASHERS
and NUTS on the lower FIXING SCREWS.
6. Tighten NUTS by hand.
While tightening the FIXING SCREW WITH CABLE SLIT hold
the cables upwards, so that these are not jammed!
7. Loosen the grub screw from the INSIDE LEVER
HANDLEslightly to remove any potential mechanical
stress from the SQUARE spindle.
8. Check whether the handle set is correctly aligned.
Long shield ILS Page 41 of 141
4.6 Assembly Option S (for Short shield holes)
Overview: Master media usage
Help & troubleshooting Technical data Maintenance & disposal Operation Administration
Assembly
Basics
To Next Page
Loading...
