9. Tighten the NUTS with the wrench (max. 1.2 Nm).
While tightening the FIXING SCREW WITH CABLE SLIT hold
the cables upwards, so that these are not jammed!
10. Tighten the grub screw of the INSIde lever handLE
again.
11. Guide the SUPPORT FRAME over the INSIDE LEVER HANDLE up
to the MOUNTING PLATE. Thereby guiding the cables
through the recess in the support frame.
Page 42 of 141 Long shield ILS
4.6 Assembly Option S (for Short shield holes)
Overview: Master media usage
Help & troubleshooting Technical data
Maintenance & disposal
Operation Administration
Assembly
Basics
To Next Page
Loading...
