18. Guide the INSIDE SHIELD over the INSIDE LEVER HANDLE and
push it up to the ASSEMBLY PLATE.
19. Guide the FIXTURE RING over the inside INSIDE LEVER
HANDLE and push it up to the end of the inside lever
handle.
20. Pull the FIXTURE RING hand-tight WITH THE CES ring
spanner (max. 1.2 Nm).
Do not over-tighten the fixture ring with too much
force! Otherwise you may damage the handle set.
21. Check whether the fitting operates friction-free with
the lock and locking cylinder.
Assembly of the handle set is now complete.
Long shield ILS Page 45 of 141
4.6 Assembly Option S (for Short shield holes)
Overview: Master media usage
Help & troubleshooting Technical data Maintenance & disposal Operation Administration
Assembly
Basics
To Next Page
Loading...
