4.7.2 Parts name Long shield ILS wide shield
1 Counter sunk screw
2 Rosette holes
3 Assembly plate of the outside fitting
4 Outside shield of the outside fitting
5 Coupling follower
4.7.3 Assembling Long shield ILS wide shield on rosette holes
The reading side of the fitting is assembled on the outside of the door; the non-reading side is
assembled on the inside.
The wide shield versions of the Long shield ILS can also be assembled on Long shield or Short
shield (option S) holes. In this case, please follow the manual "Assembling basic version (for Long
shield holes)" on page20 or "Assembly Option S (for Short shield holes)" on page34.
The manual describes the assembly on rosette holes taking the basic version of the Long
shield ILS as an example. The Long shield ILS assembly follows the same procedure.
The handle set cannot be assembled on split follower locks!
Page 48 of 141 Long shield ILS
4.7 Assembling wide shield (for rosette-holes)
Overview: Master media usage
Help & troubleshooting Technical data
Maintenance & disposal
Operation Administration
Assembly
Basics
To Next Page
Loading...
