http://www.charmhigh.com
Charmhigh-V1.0-2016 | Hunan Charmhigh mechanical and electrical co., LTD
All Rights Reserved
Figure.6- 5
(3)Move: In the left side of the window four arrows control the mount head moving in four
directions respectively, movement speed can changed by H/L button, L indicate low speed,
H indicate high speed;
(4)Enlarge: zoom up the image;
(5)Find Target: Locating component position automatically, principle explains as follows,
the algorithm search from the image center to around, the first searched close graph is
deemed to the target which marked with red rectangle. Note, the border of the target must
be clear and closed, silk printing is found generally; capture target is just auxiliary function,
silk printing position not always be the right position of component since the deviation of
process technology, user should set coordinate according to the position of footprint;
(6)Auto. center: Move nozzle to the center of target if target was captured;
(7)MHead n(n is MHead number): When use nozzle to positioning, click this button then
specified nozzle press down, for the convenience of observation;
(8)Apply: Click to apply changes.
To Next Page
Loading...
