Chapter 3
Configuring Check Point 4000
Appliances
The workflow for configuring Check Point 4000 Appliances is:
1. Connect the cables and power on the appliance.
2. Use the First Time Configuration Wizard to configure the appliance.
3. Add the Check Point 4000 Appliances object in SmartDashboard and install a policy.
In This Chapter
Powering On 21
Using the First Time Configuration Wizard 22
Creating the Network Object 26
Advanced Configuration 27
Powering On
To power on Check Point 4000 Appliances:
1. Connect the power cable.
2. On the back panel, turn on the Power button to start the appliance.
Note - For the Check Point 4800, when a power supply fails or is not
connected to the outlet, an alarm sounds continuously. If you hear the
alarm, replace the faulty power supply immediately, and connect the
new unit to an A/C outlet ("Removing the Power Supply" on page 36).
CP_Toxotai_GettingStartedGuide_421 21CP_Toxotai_GettingStartedGuide_421 21 05 July 2011 1:21:11 PM05 July 2011 1:21:11 PM
To Next Page
Loading...
