Configuring Check Point 4000 Appliances Page 27
To create the network object in SmartDashboard:
1. Launch SmartDashboard.
2. Configure a new gateway object for the appliance.
3. Enter the IP address for the appliance.
4. For a centrally managed installation, establish Secure Internal Communication (SIC) using
the activation key entered in the First Time Configuration Wizard.
5. Configure the topology.
6. Install the security policy.
Advanced Configuration
Advanced configuration can be done using the sysconfig menu which can be accessed
using the command line interface only. For example, configuring the appliance to be a DHCP
server.
Note - The sysconfig menu is only available after running the First
Time Configuration Wizard in the WebUI.
CLI access can be obtained by console connection or through SSH.
Connecting to the CLI
You can connect to the command line interface of Check Point 4000 Appliances using:
x The provided serial console cable (DTE to DTE) and terminal emulation software such as
HyperTerminal (from Windows) or Minicom (from Unix/Linux systems).
Connection parameters for the appliance are: 9600bps, no parity, 1 stop bit (8N1).
x An SSH connection to the management interface (if SSHD is configured).
CP_Toxotai_GettingStartedGuide_427 27CP_Toxotai_GettingStartedGuide_427 27 05 July 2011 1:21:11 PM05 July 2011 1:21:11 PM
To Next Page
Loading...
