EasyManua.ls Logo

Check Point 4600 - Hard Disk Drives; Rear Panel Components; Main Power Switch; Redundant Power Supply Units (Check Point 4800)

Check Point 4600
47 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Rear Panel Components
Page 34
Hard Disk Drives
The appliance contains one hard disk drive that is not hot-swappable. You must power off the
appliance before removing or installing a hard disk drive.
Rear Panel Components
This section describes components located on the rear panel of the appliance.
Main Power Switch
The main power switch controls power to the entire unit.
Redundant Power Supply Units (Check Point 4800)
The Check Point 4800 has an optional redundant power supply unit. Located at the left rear of
the appliance, two hot-swappable power supply units give built-in power redundancy. Each
power supply connects to an electrical outlet.
For appliances that are provisioned with one power supply unit, use the placeholder unit in the
other power supply slot. This diagram shows the 4800 model with the placeholder unit:
Note - If both power supply slots are not populated, a continuous alarm sounds.
If a power supply fails or is not connected to the outlet, an alarm sounds continuously.
Customer Replaceable Parts
To ensure maximum availability and ease of maintenance, the Check Point 4000 Appliances
contain the following customer replaceable parts:
4200/4600
4800
Power supply slots
n/a
2
Expansion line card
Optional
Optional
CP_Toxotai_GettingStartedGuide_434 34CP_Toxotai_GettingStartedGuide_434 34 05 July 2011 1:21:11 PM05 July 2011 1:21:11 PM

Other manuals for Check Point 4600

Related product manuals