CHINT NVF5 Series User Manual

NVF5 Series User Manual Appendix B Parameter list
Code
Name
Setting Range
Default
Change
2：No effect in Decel. Mode
F0.20
Parameter Factory
Default
0：No Effect
1：Fault Log Clear
2：Set to Factory Default（
Except
Motor NP Parameters and
Parameter F7.11）
3 ：
Reset Custom Parameter
Group to Factory Default（Except
Motor NP Parameters and
Parameter F7.11）
4：All Parameter Reset to Factory
Default
5：Back Up Parameters
6：Using Back Up Parameters
7：Saving Back Up Parameters
Note：
Only when you are using
backup parameters,backup
parameter are able to be
saved.Otherwise when power
off then re-
power the
inverter,
except the updated
parameters other parameters
are always initial value.
0
◎
F1 Start and Stop Control Group
F1.00 Start Mode Selection
0 : Start from the starting
frequency
1 : First brake and then start from
the starting frequency
2 :
Speed tracking (including
direction discrimination) and then
start
0
○
F1.01
Direct starting
frequency
（0.00 ～ 10.00）Hz
0.00Hz
○
F1.02
Starting frequency
Holding time
（0.0 ～ 100.0）s
0.0s
◎
F1.03
DC braking current
Before starting
（ 0.0 ～ 100.0 ） % （ Rated
Current）
0.0%
◎
F1.04
DC brakin time
Before starting
（0.0 ～ 100.0）s
0.0s
◎
F1.05 Stop Mode
0：Decel. Ramp Stop
1：Coast Stop
2 ：
Ramp Stop+
DC Injection
Brake
0
○
F1.06
DC braking
0.00Hz ～ F0.07
0.00Hz
○
- 114 -

CHINT NVF5 Series Specifications

General

Brand	CHINT
Model	NVF5 Series
Category	Inverter
Language	English