Chore-Time C2 PLUS User Manual

Planning the Suspension System MODEL C2® PLUS & MODEL G™ PLUS with Proximity Sensor Feeding System
8
MF2495A
1.Select the House Layout.
A. Optional Mid Line Controls may be used for partial house brooding. See .
B. Systems with line lengths over 400’ [122 m] should be split in the center, as shown in 2. This will reduce
auger running time and eliminate the need for Mid-Line Controls for partial house brooding.
2.Determine the Feed Bin location.
3.Determine the Brood Curtain location.
4.Determine the location for the End Control Pans, and if used the Mid Line Control Pans. The Feeder
Control Pans should be at least 10’ [3 m] from the Wall or Brood Curtain.
5.Determine the distance to the Feeder Line from the Side Wall.
6.Determine the distance from the Feed Hoppers to the End Wall for a Straight Line Feeding System.
Planning the Suspension System
1255-68 1/2001
Feed Bin
Feed Hopper
Mid Line Control
Brood Curtain
End Control
& Power Unit
Control Tube
Control Tube
Control Tube
Control Tube
10' [3 m]
Minimum
10' [3 m]
Minimum
Figure 1. Component location diagram for systems up to 400 feet [122 m]. (Top View).
10' [3 m]
Minimum
10' [3 m]
Minimum
1255-69 1/2001
Feed Bin
Feed Hoppers
Brood Curtain
End Control
& Power Unit
End Control
& Power Unit
Control Tube
Control Tube
Control Tube
Control Tube
Figure 2. Component location diagram for systems over 400 feet [122 m]. (Top View).

Chore-Time C2 PLUS Specifications

General

Brand	Chore-Time
Model	C2 PLUS
Category	Farm Equipment
Language	English