Installation for Layer Cage Systems Only ULTRAFLO
®
Cage Feeding Systems for Brood Grow & Layer Installations
20
MC656P
10.Install Trough Wires at every other partition, as shown in Figure 27.
Note: On 24" (610 mm) and 16" (406 mm) DURA-TRIM
TM
DBS & Manure Belt Cages,
install the Trough Wires at every partition.
11.Install the Cage Support Rod, as shown in Figure 27, at each Trough Wire, except at Cage
Floor Supports.
MMB
®
Trough Hanger and Trough Installation
5
4
3
1
2
7
6
MC656-76 8/00
Hook on left side
of partition
Key Description
1 Cage Support Rod
2 This end of Cage Support Rod should hook on
Left side of partition, top, and back wires.
3 This end of Cage Support Rod should hook
over trough and be located between partition
wire and Trough Wire.
4 Hook top of Trough Wire to partition under
line wire.
5Line wire
6 Trough Wire
7 Partition
Figure 27.Trough Wire Installation
Item Description Part No.
1 10-16 x .5 Screw 3037
2 Trough Support 50456
3 Trough Hanger 47654
4 Trough 25399-X
1
2
3
Figure 28.Trough Hanger and Trough (MMB
®
Systems)
4