The Danger of Operating
1. When the instrument is under output voltage, please don’t touch test
area or you may shock hazard and result in death.
Please obey the following items.
y Make sure the grounding cable is connected correctly and using
the standard power cord.
y Don’t touch the output terminal.
y Don’t touch test cable of connecting test termination.
y Don’t touch test termination object.
y Don’t touch any charge component of connecting output terminal.
y As the instrument end the test or turn off output, please don’t touch
test unit immediately.
2. The shock accidents are usually occurred on the following conditions.
y The grounding terminal of the instrument doesn’t connect correctly.
y Do not use insulation glove for testing.
y After test is completed to touch test unit immediately.
3. Remote Control for the instrument: This instrument provided with
remote control, normally using the external signal to control to high
voltage output. For safety reasons and prevent from hazards, please
exactly follow instructions below while using remote control.
y Unexpected high voltage output may exist. Make sure if this
instrument is under testing/remote controlling before access to the
probes.
y When the instrument is under testing/operating, any access to DUT,
test cable and probe output terminal are prohibited, both for the
operator/service personnel.
y Normally remote control of this instrument is controlled by the high
voltage test bar. However, using of other control circuit is also
possible. For safety reasons and prevent from hazards, please
notice that unintentional access to the control test bar or bridging
the control circuit to high voltage terminal and test cables may
cause hazards. Please keep this terminal/control from
unintentional bridging/access to avoid danger.
WARNING
Don't tie HV cable, RS232, Handler, GPIB control
cable and other low voltage cable together. Or it
may cause product damaged or PC crashed.
viii
To Next Page
Loading...
