Safety Summary
The following general safety precautions must be observed during all
phases of operation, service, and repair of this instrument. Failure to
comply with these precautions or specific WARNINGS given elsewhere in
this manual will violate safety standards of design, manufacture, and
intended use of the instrument. Chroma assumes no liability for the
customer’s failure to comply with these requirements.
BEFORE APPLYING POWER
Verify that the power is set to match the rated input of
this power supply.
PROTECTIVE GROUNDING
Make sure to connect the protective grounding to
prevent an electric shock before turning on the power.
NECESSITY OF PROTECTIVE GROUNDING
Never cut off the internal or external protective
grounding wire, or disconnect the wiring of protective
grounding terminal. Doing so will cause a potential
shock hazard that may bring injury to a person.
FUSES
Only fuses with the required rated current, voltage, and
specified type (normal blow, time delay, etc.) should be
used. Do not use repaired fuses or short-circuited
fuse holders. To do so could cause a shock or fire
hazard.
DO NOT OPERATE IN AN EXPLOSIVE
ATMOSPHERE
Do not operate the instrument in the presence of
flammable gases or fumes. The instrument should be
used in an environment of good ventilation.
DO NOT REMOVE THE COVER OF THE
INSTRUMENT
Operating personnel must not remove the cover of the
instrument. Component replacement and internal
adjustment can be done only by qualified service
personnel.
vi
To Next Page
Loading...
