Chroma 63200 Series User Manual

System Structure
1. System Structure
This chapter explains the structure and functions of Chroma DC Load 63200 Series Soft
Panel application. The supported instruments and communication interfaces are listed below
for users to identify the required environment easily.
1.1 Introduction
This software is applicable to Chroma DC Load 63200 Series instruments only. The remote
transmission between PC and DC Load must be active before using the software in order to
communicate by commands.
The software application can perform internal parameter settings for DC Load and monitor
the output measurement. In addition the software is able to save the parameter settings so
that users can open an existing file for execution from hard disk easily.
1.2 Supported Hardware
Chroma 63200 Series Programmable DC Electronic Load contain the following models:
A. 63201
B. 63202
C. 63203
D. 63204
E. 63205
F. 63206
G. 63207
H. 63208
I. 63209
J. 63210
1.3 Communication Interface
There are two types of communication interfaces between PC and DC Loads:
A. GPIB
B. RS232 (Cross)
1.4 Operation
It is recommended to work through the Soft Panel by clicking the mouse for operation.
1-1

Chroma 63200 Series Specifications

General

Brand	Chroma
Model	63200 Series
Category	Test Equipment
Language	English