Chroma 63200 Series - Setting Run Time

Program Test
Figure 7-13 Step Mode Parameter
7.3.1 Setting Start_Loading
It sets the start loading of each channel under Step. The Loading range changes not only
according to the Mode but also following the Model. Moreover, it changes according to
parallel use which should be kept in mind. When the input value exceeds the maximum
range, it will stay at the maximum and same for the minimum.
Figure 7-14 Setting Start_Loading
7.3.2 Setting End_Loading
It sets the end loading of each channel under Step. The Loading range changes not only
according to the Mode but also following the Model. Moreover, it changes according to
parallel use which should be kept in mind. When the input value exceeds the maximum
range, it will stay at the maximum and same for the minimum.
Figure 7-15 Setting End_Loading
7.3.3 Setting Run Time
It sets the total execution time for the Step that is same for all channels. The unit is second.
Figure 7-16 Setting Run Time
7-5