Installation
2. Installation
First install the Chroma DC Load 63200 Soft Panel to the hard disk on PC before using it.
This chapter describes how to install the software on Windows step by step.
Ensure there is at least 40 MB or above hard disk space on PC.
Insert the first floppy disk of Chroma DC Load 63200 Soft Panel to the 3.5” disk drive, or
place the software CD into the CD drive.
2.1 Files in CD
The CD contains the files shown in Figure 2-1.
Figure 2-1 Files in CD
2.2 Installing Chroma 63200 Soft Panel
Place CD in the CD drive and it will execute “Setup.exe” in the CD to start the installation
wizard as Figure 2-2 shows. Execute it manually if it is not running automatically.
Figure 2-2 Soft Panel Setup Screen
2-1
To Next Page
Loading...
Need help?
General
