High Power DC Electronic Load 63200 Series Soft Panel User’s Manual
Figure 4-3 Indication when Communication Check Pass
4.1 Using Demo Mode
The software will enter into Demo mode if no hardware device is connected, and users can
understand the functions of Soft Panel through the Demo program.
4.2 Using Output Name and Active
Users can set the Output Name as they like; however, it is suggested not to exceed 7
characters. The reason is that the test report format of Program Function, Battery Function
and OCP Function for Output Name allows 7 characters only. Users should take this
restriction under consideration when naming. The default setting is True indicating the
mapped channel is active. Users can specify the channel to be inactive without changing
the hardware connection by clearing the check box. The Soft Panel will not send any
command to the hardware device.
Figure 4-4 Output Name
Figure 4-5 Active
4-2
To Next Page
Loading...
