CipherLab 8 Series User Manual

196
CipherLab BASIC Programming Part I
Verify Check Digit
Select one of the three calculations to perform check digit verification when decoding barcodes.
 If true and the check digit found incorrect, the barcode will not be accepted.
Transmit Check Digit
Decide whether or not to include the check digit in the data being transmitted.
Length Qualification
Because of the weak structure of the symbology, it is possible to make a “short scan”
error. To
prevent the “short scan” error, define the “Length Qualification”
settings to ensure that the correct
barcode is read by qualifying the allowable code length.
 If “Fixed Length” is selected, up to 2 fixed lengths can be specified.
 If “Max/Min Length”
is selected, the maximum length and the minimum length must be
specified. It only accepts those barcodes with lengths that fall between max/min lengths
specified.
NEGATIVE BARCODE
No. (N1%)
Values (N2%) & Description
Default
Scan Engine
55 1: Enable Negative Barcode
0: Disable Negative Barcode
1 CCD, Laser
,
8700 –
Long
Range
PLESSEY
No. (N1%)
Values (N2%) & Description
Default
Scan Engine
20 1: Enable Plessey
0: Disable Plessey
0 CCD, Laser
,
8700 –
Long
Range
41 1: Transmit Plessey Check Digits
0: DO NOT transmit Plessey Check Digits
1 CCD, Laser
,
8700 –
Long
Range
42 1: Convert Standard Plessey to UK Plessey
0: No conversion
1 CCD, Laser
,
8700 –
Long
Range
316 1: Skip checking Plessey quiet zone
0: Check Plessey quiet zone
1 8200/8400
CCD, Laser
Transmit Check Digits
Decide whether or not to include the two check digits in the data being transmitted.
Convert to UK Plessey
Decide whether or not to change each occurrence of the character ‘A’ to character ‘X’
in the
decoded data.

CipherLab 8 Series Specifications

General

Brand	CipherLab
Model	8 Series
Category	PDA
Language	English