CipherLab 8 Series User Manual

224
CipherLab BASIC Programming Part I
READ REDUNDANCY
This parameter is used to specify the level of reading security. You will have to
compromise between reading security and decoding speed.
No. (N1%)
Values (N2%) & Description
Default
Scan Engine
56 3: Three Times Read Redundancy for Scanner Port 1
2: Two Times Read Redundancy for Scanner Port 1
1: One Time Read Redundancy for Scanner Port 1
0: No Read Redundancy for Scanner Port 1
0 CCD, Laser
,
8700 –
Long
Range
182 2: Two Times Read Redundancy
1: One Time Read Redundancy
0: No Read Redundancy
0 2D,
8300 –
Long
Range
 No Redundancy:
If “No Redundancy” is selected, one successful decoding will make the reading valid
and induce the “READER Event”.
 One/Two/Three Times:
If “Three Times” is selected, it will take a total of four consecutive successful
decodings of the same barcode to make the reading valid. The higher the reading
security is (that is, the more redundancy the user selects), the slower the reading
speed gets.
TIME-OUT
These parameters are used to limit the maximum scanning time interval for a specific
scan mode.
No. (N1%)
Values (N2%) & Description
Default
Scan Engine
72 Scanner time-
out duration in seconds for Aiming mode,
Laser mode, Auto Off mode, and Auto Power Off mode
1 ~ 255 (sec): Decode time-out
0: No time-out
3 sec.
CCD, Laser
,
8700 –
Long
Range
145 Scanner time-out duration in seconds for
Aiming mode,
Laser mode and Auto-off mode
1 ~ 255 (sec): Decode time-out
0: No time-out (= always scanning)
3 sec.
2D, (Extra)
Long Range
149 Aiming time-out duration for Aiming mode
1 ~ 65535 (in units of 5 milliseconds): Aiming time-out
0: No aiming
200
(= 1
sec.)
CCD, Laser;
2D, (Extra)
Long Range

CipherLab 8 Series Specifications

General

Brand	CipherLab
Model	8 Series
Category	PDA
Language	English