CipherLab 8 Series

223
Appendix III Scanner Parameters
Aiming Mode
Press the scan trigger to aim
at a barcode. Within one second, press the trigger again to decode
the barcode.
 The scanning won't stop until (a) a barcode is decoded, (b) the preset timeout expires
, or (c)
you release the trigger.
Laser Mode
Hold down the scan trigger to start with scanning.

The scanning won't stop until (a) a barcode is decoded, (b) the preset timeout expires, or (c)
you release the trigger.
Auto Off Mode
Press the scan trigger to start with scanning.
 The scanning won't stop until (a) a barcode is decoded, or (b) the preset timeout expires.
Auto Power Off Mode
Press the scan trigger to start with scanning.
 The scanning won't stop until the pre-
set timeout expires, and, the preset timeout period
re-counts after each successful decoding.