CipherLab 8000 Series Reference Manual

74 8000 Series Reference Manual
The reader does not decode after scanning…
Unreadable barcode -
 Check if the barcode is defaced. A defaced barcode may not be readable.
Un-programmed to read -
 Check if the scanner is programmed to read the symbologies (types of barcode) that you are
trying to read.
 Try scanning a test barcode of the symbology you are trying to read.
Dirty scan window-
 Check if the scan window gets dirty. Wipe it with a clean and dry cloth, and try again.
Out of scanning range -
 Try adjusting the scanning distance from the scanner to the barcode.
The mobile computer cannot transmit/receive data to/from a host computer or other devices…
Over IR port -
 Make sure the mobile computer's infrared port is pointed directly to the infrared port of another
IR device. The distance between the mobile computer and a target device is within proper
range, and no obstacles in between. Try to establish connection again.
Via Bluetooth -
 Make sure the distance between the mobile computer and a target device is within proper
range. Try to establish connection again.
 Check if the relevant settings are correct. (see
4.1.7)
 Check if the connection is working properly. (see
4.1.7)
Over RS-232 port via cradle -
 Check if the RS-232 connection is correct and secured.
 Make sure the serial port parameters on the host are configured to match the serial parameters
on the mobile computer. Try to establish connection again.
 Make sure the mobile computer is well seated inside the cradle. DO NOT remove the mobile
computer or disconnect the cradle before communications are done.
 If the problem persists, run the IR Echo Test to check the IR interface between the mobile
computer and the cradle. (see
4.1.3)

CipherLab 8000 Series Specifications

General

Humidity	5% to 95% non-condensing
Communication	Infrared
Barcode Scanner	Laser
Connectivity	Infrared
Storage Temperature	-20°C to 60°C
Keypad	21 keys (numeric / functional)