CipherLab Cipher Lab 1560 User Manual

42
Enter Setup
1560 Series Barcode Scanner User Guide
1.6.6 ALTERNATE MODE
The scanner will start scanning once the trigger is pressed
 The scanning won't stop until you press the trigger again.
Alternate Mode
1.6.7 AIMING MODE
The scanner will aim at a barcode once the trigger is pressed, and start scanning when
the trigger is pressed again within one second.
 The scanning won't stop until (1) a barcode is decoded, and (2) the pre-set timeout
expires.
Aiming Mode
Aiming Timeout
You can limit the aiming time interval (1~15). By default, the scanner time-out is set to 1 second.
Aiming Time-out
a
fter 1~15 sec.
(*1)
1. Read the barcode above to specify the time interval before aiming ends. (It is set to 1 by
default.)
2. Read the “Decimal Value” barcode on page 227. For example, read “1” and “0” for the scanner
to automatically shut down after idleness for 10 seconds.
3. Read the “Validate” barcode on the same page to complete this setting.

CipherLab Cipher Lab 1560 Specifications

General

Brand	CipherLab
Model	Cipher Lab 1560
Category	Barcode Reader
Language	English