CipherLab RK25WO

193
Using Reader Configuration Utility
SEND CHARACTER
Command
Description
Send character
To add a specific character in front of the output data.
Example
The decoded data:
0001112223334
Actions:
Send the character “C”.
Send up to “5” characters
The output data:
C00011
SEND KEYEVENT
Command
Description
Send key event
To make a “Send key event” action to be effective, “Keyboard
Emulation” should be set as “KeyEvent”.
The following example is to output the data to two fields by
“KeyEvent”:
Example
The decoded data:
21234569
Actions:
Send data Next 4
Send KeyEvent 0x1D
Sebd Data Next 4
The output data:
Note: The decoded data is processed by actions sequentially. The permutation of actions affects
the output data, that is, different permutations of actions may result in different output data.