Switch to enable ISBT 128 decoding.
Sets whether to enable decoding ISBT 128 by performing
concatenation of ISBT data.
Disable: Does not perform concatenation
Enable: Performs concatenation on all ISBT-128 barcodes.
Auto-discriminate: Auto-discriminates between the ISBT 128
barcodes which require concatenation and those which do
not need concatenation.
When “Auto-discriminate” is applied, decide the number
of times of supplementary decoding the same barcode to
count as a valid read. Configurable between 2 and 20.
Switch to enable Chinese 2 of 5 decoding.
Switch to enable Discrete 2 of 5 decoding.
Sets the length of the Discrete 2 of 5 symbols to decode.
One Fixed length (Length 1)
Two Fixed lengths (Length 1>Length 2)
Max / Min Length (range: 0-55; Length 1<Length 2)
Any Length
Switch to enable Interleaved 2 of 5 decoding.
Sets the length of Interleaved 2 of 5 symbols to decode.
One Fixed length (Length 1)
Two Fixed lengths (Length 1>Length 2)
Max / Min Length (range: 0-55; Length 1<Length 2)
Any Length
Decide whether to verify the check digit. If the check digit
is incorrect, the barcode will not be accepted.
Decide whether to include the check digit in the data to
transmit.
Convert a 14-character Interleaved 25 barcode into
EAN-13 if the following requirements are met:
The barcode must have a leading 0 and a valid EAN-13 check
digit.
Select the security level from Level 0 to Level 3
To Next Page
Loading...
Need help?
General
