Cisco 2950G 24 - Catalyst Switch - Page 10

Contents
x
Catalyst 2950 Desktop Switch Software Configuration Guide
78-14982-01
Changing the Switch-to-Client Retransmission Time 8-12
Setting the Switch-to-Client Frame-Retransmission Number 8-13
Enabling Multiple Hosts 8-13
Resetting the 802.1X Configuration to the Default Values 8-14
Displaying 802.1X Statistics and Status 8-14
CHAPTER 9 Configuring the Switch Interfaces 9-1
Understanding Interface Types 9-1
Access Ports 9-2
Trunk Ports 9-2
Port-Based VLANs 9-3
EtherChannel Port Groups 9-3
Connecting Interfaces 9-3
Using the Interface Command 9-4
Procedures for Configuring Interfaces 9-4
Configuring a Range of Interfaces 9-6
Configuring and Using Interface-Range Macros 9-8
Configuring Switch Interfaces 9-9
Default Ethernet Interface Configuration 9-10
SFP Configuration 9-10
Configuring Interface Speed and Duplex Mode 9-11
Configuration Guidelines 9-12
Setting the Interface Speed and Duplex Parameters 9-13
Configuring Media Types for Gigabit Interfaces 9-14
Configuring IEEE 802.3X Flow Control on Gigabit Ethernet Ports 9-14
Adding a Description for an Interface 9-16
Monitoring and Maintaining the Interfaces 9-16
Monitoring Interface and Controller Status 9-16
Clearing and Resetting Interfaces and Counters 9-19
Shutting Down and Restarting the Interface 9-19
CHAPTER 10 Configuring LRE 10-1
Ports on the 2950 LRE 10-1
LRE Links and LRE Profiles 10-2
LRE Profiles 10-2
LRE Sequences 10-4
CPE Ethernet Links 10-5
Configuring LRE Ports 10-5
Environmental Guidelines for LRE Links 10-6