4-12
Catalyst 2950 Desktop Switch Software Configuration Guide
78-14982-01
Chapter 4 Assigning the Switch IP Address and Default Gateway
Checking and Saving the Running Configuration
no ip address
shutdown
!
interface Vlan1
ip address 172.20.139.133 255.255.255.224
no ip route-cache
!
ip default-gateway 172.20.139.129
ip http server
!
ip access-list extended CMP-NAT-ACL
!
snmp-server engineID local 8000000903000005742809C1
snmp-server community public RO
snmp-server community public@es0 RO
snmp-server enable traps MAC-Notification
!
line con 0
password letmein
line vty 0 4
password letmein
login
line vty 5 15
password letmein
login
!
end
To store the configuration or changes you have made to your startup configuration in Flash memory,
enter this privileged EXEC command:
Switch# copy running-config startup-config
Destination filename [startup-config]?
Building configuration...
This command saves the configuration settings that you made. If you fail to do this, your configuration
will be lost the next time you reload the system. To display information stored in the NVRAM section
of Flash memory, use the show startup-config or more startup-config privileged EXEC command.
To Next Page
Loading...
Need help?
General
