Cisco 2950G 24 - Catalyst Switch - Page 15

Contents
xv
Catalyst 2950 Desktop Switch Software Configuration Guide
78-14982-01
Configuring the VMPS Client 14-28
Entering the IP Address of the VMPS 14-28
Configuring Dynamic Access Ports on VMPS Clients 14-29
Reconfirming VLAN Memberships 14-30
Changing the Reconfirmation Interval 14-30
Changing the Retry Count 14-30
Monitoring the VMPS 14-31
Troubleshooting Dynamic Port VLAN Membership 14-31
VMPS Configuration Example 14-32
CHAPTER 15 Configuring VTP 15-1
Understanding VTP 15-1
The VTP Domain 15-2
VTP Modes 15-3
VTP Advertisements 15-3
VTP Version 2 15-4
VTP Pruning 15-4
Configuring VTP 15-6
Default VTP Configuration 15-6
VTP Configuration Options 15-7
VTP Configuration in Global Configuration Modes 15-7
VTP Configuration in VLAN Configuration Mode 15-7
VTP Configuration Guidelines 15-8
Domain Names 15-8
Passwords 15-8
Upgrading from Previous Software Releases 15-8
VTP Version 15-9
Configuration Requirements 15-9
Configuring a VTP Server 15-9
Configuring a VTP Client 15-11
Disabling VTP (VTP Transparent Mode) 15-12
Enabling VTP Version 2 15-13
Enabling VTP Pruning 15-14
Adding a VTP Client Switch to a VTP Domain 15-15
Monitoring VTP 15-16
CHAPTER 16 Configuring Voice VLAN 16-1
Understanding Voice VLAN 16-1
Configuring Voice VLAN 16-2