6-11
Firepower 7000 and 8000 Series Installation Guide
Chapter 6 Using the LCD Panel on a Firepower Device
Error Alert Mode
Use the following procedure to view hardware alert error messages on the LCD display.
To view the hardware alert error messages:
Step 1 In Error Alert mode, on the HARDWARE ERROR! line, press the right arrow ( ) key to view the
hardware errors that triggered the Error Alert mode.
The LCD panel lists the error alert messages starting with the
NFE platform daemon failure followed by
a list of error messages.
NFEplatformdX
NFEtempX
where X indicates the accelerator card (either 0 or 1) that generated the alert.
Step 2 On the error message line, press the down arrow (â) key to view additional errors. When there are no
additional errors, the Exit row appears.
Exit
Step 3 Press the right arrow ( ) key to exit Error Alert mode.
If you exit Error Alert mode before you resolve the error that triggered the alert, the LCD panel returns
to Error Alert mode. Contact Support for assistance.
7000 Series only: gftw
8000 Series only:
ftwo
ftwo
daemon status Alerts when the ftwo daemon fails.
NFE_port18
NFE_port19
NFE_port20
NFE_port21
internal link status Alerts when the link between the network module switch board and
the accelerator card fails:
• 7000 Series
All families:
NFE_port18 only
• 8000 Series
81xx Family:
NFE_port18 and NFE_port19 only
82xx Family and 83xx Family:
NFE_port18, NFE_port19,
NFE_port20, and NFE_port21
Table 6-5 Hardware Alarm Error Messages (continued)
Error Message Condition Monitored Description
To Next Page
Loading...
