Cisco 7010 - Appliances Delivered with Version 6.0

1-4
Firepower 7000 and 8000 Series Installation Guide
Chapter 1 Introduction to the Firepower System
Firepower System Appliances
• ASA FirePOWER devices do not support the Firepower System’s hardware-based features: high
availability, stacking, switching, routing, VPN, NAT, and so on. However, the ASA platform does
provide these features, which you can configure using the ASA CLI and ASDM. See the ASA
documentation for more information.
• You cannot use the Firepower Management Center web interface to configure ASA FirePOWER
interfaces. The Firepower Management Center does not display ASA interfaces when the
ASA FirePOWER device is deployed in SPAN port mode.
• You cannot use the Firepower Management Center to shut down, restart, or otherwise manage
ASA FirePOWER processes.
ASA FirePOWER devices have a software and command line interface (CLI) unique to the ASA
platform. You use these ASA-specific tools to install the system and to perform other platform-specific
administrative tasks.
Note If you edit an ASA FirePOWER device and switch from multiple context mode to single context mode
(or visa versa), the device renames all of its interfaces. You must reconfigure all Firepower System
security zones, correlation rules, and related configurations to use the updated ASA FirePOWER
interface names.
Appliances Delivered with Version 6.0
The following table lists the appliances that Cisco delivers with Version 6.0 of the Firepower System.
Table 1-1 Version 6.0 Firepower System Appliances
Models/Family Firepower Series Form Type
70xx Family:
• 7010, 7020, 7030, 7050
7000 Series hardware device
71xx Family:
• 7110, 7120
• 7115, 7125
• AMP7150
7000 Series hardware device
80xx Family:
• AMP8050
8000 Series hardware device
81xx Family:
• 8120, 8130, 8140
• AMP8150
8000 Series hardware device
82xx Family:
• 8250
• 8260, 8270, 8290
8000 Series hardware device