Cisco 7010 - Removing a Module or Slot Cover

C-5
Firepower 7000 and 8000 Series Installation Guide
Appendix C Inserting and Removing Firepower 8000 Series Modules
Removing a Module or Slot Cover
Caution Yo u cannot hot-swap modules. You must power down and unplug both power cords from the appliance
before inserting or removing modules.
Removing a Module or Slot Cover
Use proper electrostatic discharge (ESD) practices such as wearing wrist straps and using an ESD work
surface when handling the modules. Store unused modules in an ESD bag or box to prevent damage.
To remove a module or slot cover:
Step 1 Remove and reserve the T8 Torx screw from the lever of the module using the included screwdriver.
Step 2 Pull the lever away from the module to release the latch.
Step 3 Slide the module out of the slot.