Contents
3
Firepower 7000 and 8000 Series Installation Guide
Using the Shell 4-22
Using the Web Interface 4-23
Testing an Inline Bypass Interface Installation 4-24
Setting Up Firepower Managed Devices 5-1
Understanding the Setup Process 5-2
Beginning the Setup 5-2
Performing Initial Setup on a Firepower Device Using the CLI 5-3
Registering a Firepower Device to a Management Center Using the CLI 5-4
Initial Setup Page: Firepower Devices 5-5
Next Steps 5-9
Using the LCD Panel on a Firepower Device 6-1
Understanding LCD Panel Components 6-2
Using the LCD Multi-Function Keys 6-3
Idle Display Mode 6-4
Network Configuration Mode 6-4
Allowing Network Reconfiguration Using the LCD Panel 6-6
System Status Mode 6-7
Information Mode 6-8
Error Alert Mode 6-9
Hardware Specifications 7-1
Rack and Cabinet Mounting Options 7-1
Firepower 7000 Series Devices 7-1
Firepower 7010, 7020, 7030, and 7050 7-1
Firepower 7110 and 7120 7-6
Firepower 7115, 7125, and AMP7150 7-13
Firepower 8000 Series Devices 7-21
Firepower 8000 Series Chassis Front View 7-22
Firepower 8000 Series Chassis Rear View 7-26
Firepower 8000 Series Physical and Environmental Parameters 7-29
Firepower 8000 Series Modules 7-32
Restoring a Firepower System Appliance to Factory Defaults 8-1
Before You Begin 8-1
Configuration and Event Backup Guidelines 8-1
Traffic Flow During the Restore Process 8-1
Understanding the Restore Process 8-2
To Next Page
Loading...
