4-25
Firepower 7000 and 8000 Series Installation Guide
Chapter 4 Installing a Firepower Managed Device
Testing an Inline Bypass Interface Installation
Step 10 For Firepower devices that support tap mode, you can test and record ping latency results under the
following sets of conditions:
• device powered off
• device powered on, policy with no rules applied, inline intrusion policy protection mode
• device powered on, policy with no rules applied, inline intrusion policy protection tap mode
• device powered on, policy with tuned rules applied, inline intrusion policy protection mode
Ensure that the latency periods are acceptable for your installation. For information on resolving
excessive latency problems, see Configuring Packet Latency Thresholding and Understanding Rule
Latency Thresholding in the Firepower Management Center Configuration Guide.
To Next Page
Loading...
