Note
Saf-D-Grid plug has a retaining latch that must be depressed and gently pulled to release the plug from the
receptacle.
Figure 54: SAF-D-Grid Plug
Step 7 If the power supply is connected to a AC or DC circuit, turn on the circuit breaker for the AC or DC power
source. After replacing the PSU, verify the power using the show environment power command.
Step 8 Verify that the power indicator LED on the front of the power module goes on.
Hardware Installation Guide for Cisco 8500 Switches
88
Replace Chassis Components
Replace Power Module
To Next Page
Loading...
