Add a Third Party to a Conference
Procedure
Step 1
Start with a connected call that is not on hold.
Step 2
Press Conference and do one of the following:
•
Enter the phone number for the party you want to add and press Call.
•
Press a speed-dial button.
•
Press Speed Dial, enter a speed-dial number, and press Speed Dial again.
•
Press Active Calls and select a call.
•
Select a call from the Call History.
Step 3
Wait for the party to answer or skip to step 4 while the call is ringing.
Step 4
Press Conference.
The conference begins.
Join Calls Into a Conference
The conference is established on the line that had the active call.
Your system administrator controls the ability to transfer calls from one line to another line.
Procedure
Step 1
Start with two connected calls.
Step 2
Make sure that one of the calls is active (not on hold). If both calls are on hold, resume one call.
Step 3
Press Conference .
Step 4
Press the line button for the other (held) call or if the held call is on another line:
a) Press Active Calls.
b) Choose a call from the list.
c) Press Conference.
The conference begins. The conference is established on the line that had the active call.
Swap Between Calls Before Completing a Conference
You can consult privately with the conference and another person, before adding the person into the conference.
Cisco IP Phone 8811, 8841, 8845, 8851, 8851NR, 8861, and 8865 User Guide for Cisco Unified Communications
Manager 11.0
74
Advanced Calling Features
Add a Third Party to a Conference
REVIEW DRAFT - CISCO CONFIDENTIAL
To Next Page
Loading...
Need help?
General
