Cisco 8861 - XML Directory Service; Configure a Phone to Connect to an XML Application

• CiscoIPPhoneIconMenu
• CiscoIPPhoneStatus
• CiscoIPPhoneExecute
• CiscoIPPhoneImage
• CiscoIPPhoneImageFile
• CiscoIPPhoneGraphicMenu
• CiscoIPPhoneFileMenu
• CiscoIPPhoneStatusFile
• CiscoIPPhoneResponse
• CiscoIPPhoneError
• CiscoIPPhoneGraphicFileMenu
• Init:CallHistory
• Key:Headset
• EditDial:n
The full list of supported URIs is contained in Cisco Unified IP Phone Services Application Development
Notes for Cisco Unified Communications Manager and Multiplatform Phones, located here:
https://www.cisco.com/c/en/us/support/collaboration-endpoints/ip-phone-8800-series-multiplatform-firmware/
products-programming-reference-guides-list.html
XML Directory Service
When an XML URL requires authentication, use the parameters XML UserName and XML Password.
The parameter XML UserName in XML URL is replaced by $XML UserName.
For example:
The parameter XML UserName is cisco. The XML Directory Service URL is
http://www.sipurash.compath?username=$XML_User_Name.
This results in the request URL: http://www.sipurash.com/path?username=cisco.
Configure a Phone to Connect to an XML Application
You can also configure the parameters in the configuration file (cfg.xml) as defined in Parameters for XML
Applications, on page 166.
Before you begin
Access the phone administration web page. See Access the Phone Web Interface, on page 104.
Cisco IP Phone 8800 Series Multiplatform Phone Administration Guide for Release 11.3(1) and Later
165
Cisco IP Phone Configuration
XML Directory Service