Cisco 8861 - Set the Phone Privacy Header

Set the Phone Privacy Header
A user privacy header in the SIP message sets user privacy needs from the trusted network.
You can set the user privacy header value for each line extension using an XML tag in the config.xml
file.
The privacy header options are:
• Disabled (default)
• none—The user requests that a privacy service applies no privacy functions to this SIP message.
• header—The user needs a privacy service to obscure headers which cannot be purged of identifying
information.
• session—The user requests that a privacy service provide anonymity for the sessions.
• user—The user requests a privacy level only by intermediaries.
• id—The user requests that the system substitute an id that doesn't reveal the IP address or host name.
Procedure
Step 1 Edit the phone config.xml file in a text or XML editor.
Step 2 Insert the <Privacy_Header_N_ ua="na">Value</Privacy_Header_N_> tag, where N is the
line extension number (1–10), and use one of the following values.
• Default value: Disabled
• none
• header
• session
• user
• id
Step 3 (Optional) Provision any addition line extensions using the same tag with the required line extension number.
Step 4 Save the changes to the config.xml file.
Cisco IP Phone 8800 Series Multiplatform Phone Administration Guide for Release 11.3(1) and Later
66
Cisco IP Phone Provisioning
Set the Phone Privacy Header