Cisco 8861 - SIP Configuration; Configure the Basic SIP Parameters

DescriptionParameter
Allows you to enter password for the network profile
that you create. You need to enter this value when the
security mode is PSK.
Passphrase
Allows you to select the wireless signal frequency
band that is used in the WLAN. Options are:
• Auto
• 2.4 GHz
• 5 GHz
Default: Auto
Frequency band
Step 7 Press Save.
SIP Configuration
SIP settings for the Cisco IP Phone are configured for the phone in general and for the extensions.
Configure the Basic SIP Parameters
Before you begin
Access the phone administration web page. See Access the Phone Web Interface, on page 104.
Procedure
Step 1 Select Voice > SIP.
Step 2 In the SIP Parameters section, set the parameters as described in the SIP Parameters, on page 340 table.
Step 3 Click Submit All Changes.
Cisco IP Phone 8800 Series Multiplatform Phone Administration Guide for Release 11.3(1) and Later
339
Cisco IP Phone Installation
SIP Configuration