Cisco 8861 - Configure a Phone to Accept Pages Automatically; Manage Phones with

DescriptionFeature
Perform one of the following:
• In the phone configuration file with XML(cfg.xml), enter a string in this format:
<Group_1_Paging_Script
ua="na">pggrp=224.168.168.168:34560;name=Group_1;
num=800;listen=yes;pri=1;codec=g722</Group_1_Paging_Script>
• In the phone web interface, configure this field with a valid string.
Default:
pggrp=224.168.168.168:34560;name=All;num=800;listen=yes;
Configure a Phone to Accept Pages Automatically
The Single Paging or Intercom feature enables a user to directly contact another user by phone. If the phone
of the person being paged has been configured to accept pages automatically, the phone does not ring. Instead,
a direct connection between the two phones is automatically established when paging is initiated.
You can also configure the parameters in the phone configuration file with XML(cfg.xml) code.
Before you begin
Access the phone administration web page. See Access the Phone Web Interface, on page 104.
Procedure
Step 1 Select Voice > User.
Step 2 In the Supplementary Services section, choose Yes for the Auto Answer Page parameter.
You can configure this parameter in the phone configuration XML file (cfg.xml) by entering a string in this
format:
<Auto_Answer_Page ua="na">Yes</Auto_Answer_Page>
Options: Yes and No
Default: Yes
Step 3 Click Submit All Changes.
Manage Phones with TR-069
You can use the protocols and standards defined in Technical Report 069 (TR-069) to manage phones. TR-069
explains the common platform for management of all phones and other customer-premises equipment (CPE)
in large-scale deployments. The platform is independent of phone types and manufacturers.
Cisco IP Phone 8800 Series Multiplatform Phone Administration Guide for Release 11.3(1) and Later
185
Cisco IP Phone Configuration
Configure a Phone to Accept Pages Automatically