EasyManua.ls Logo

Cisco 8861 - Enable Auto Provisioning with Short Activation Code; Manually Provision a Phone from the Keypad

Cisco 8861
544 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
<!-- <BACKUP_ACS_Password ua="na"/> -->
</flat-profile>
</device>
Step 3 Save the changes to the config.xml file.
Enable Auto Provisioning with Short Activation Code
Use the steps below to enable auto provisioning with a short activation code.
Before you begin
Ensure that your phones are updated with Firmware Release 11.3(1) or later.
Review how to set up the CDA server for redirection profile:
https://community.cisco.com/t5/collaboration-voice-and-video/cisco-multi-platform-phones-cloud-provisioning-process/ta-p/3910244
Procedure
Step 1 Create a redirection profile name that contains a any number of digits between three and 16, inclusive. This
becomes the activation code, later. Use one of these formats:
nnn.
nnnnnnnnnnnnnnnn
Any number of digits between three and sixteen, inclusive. Example, 123456
Step 2 Provide the profile name that you created in step 1 to the Customer Device Activation (CDA) support team
at cdap-support@cisco.com.
Step 3 Ask the CDA support team to enable your profile for discovery.
Step 4 When you get confirmation from the CDA support team, distribute the activation code to the users.
Step 5 Instruct users to press pound (#) before entering the digits at the activation screen.
Manually Provision a Phone from the Keypad
Procedure
Step 1 Press Applications .
Step 2 Select Device administration > Profile Rule.
Step 3 Enter the profile rule using the following format:
protocol://server[:port]/profile_pathname
For example:
Cisco IP Phone 8800 Series Multiplatform Phone Administration Guide for Release 11.3(1) and Later
26
Cisco IP Phone Provisioning
Enable Auto Provisioning with Short Activation Code

Table of Contents

Other manuals for Cisco 8861

Related product manuals