Cisco 8861 - Page 422

syntax of the string that is added in the phone configuration file with XML(cfg.xml) code to configure a
parameter.
Table 82: Parameters for Control Timer Values (sec)
DescriptionParameter
Delay after far end hangs up before reorder (busy)
tone is played.
Perform one of the following:
• In the phone configuration file with
XML(cfg.xml), enter a string in this format:
<Reorder_Delay
ua="na">255</Reorder_Delay>
• In the phone web page, set a value in seconds
ranges from 0-255 secs.
0 = plays immediately, inf = never plays. Set to 255
to return the phone immediately to on-hook status and
to not play the tone.
Allowed values: 0–255 seconds
Default: 255
Reorder Delay
Long timeout between entering digits when dialing.
The interdigit timer values are used as defaults when
dialing. The Interdigit_Long_Timer is used after any
one digit, if all valid matching sequences in the dial
plan are incomplete as dialed.
Perform one of the following:
• In the phone configuration file with
XML(cfg.xml), enter a string in this format:
<Interdigit_Long_Timer
ua="na">10</Interdigit_Long_Timer>
• In the phone web page, set a value in seconds
ranges from 0-64 seconds.
Allowed values: 0–64 seconds
Default: 10
Interdigit Long Timer
Cisco IP Phone 8800 Series Multiplatform Phone Administration Guide for Release 11.3(1) and Later
402
Cisco IP Phone Installation
Parameters for Control Timer Values (sec)