112 OL-19963-01
• Once a Bluetooth headset is connected, turning it off/on will reconnect it to the phone. Please read
the below mentioned instructions before using the Bluetooth headset.
–
If you have both, a Bluetooth headset and an analog headset attached to the phone, only one
type of headset will work at any given time. Using a USB headset will disable both, the
Bluetooth and analog headset.
–
Enable the Bluetooth headset to disable the analog headset.
–
Disable the Bluetooth headset to enable the analog headset
–
Unplug the USB headset and then enable wither the Bluetooth headset or analog headset.
• It is recommended that you use your Bluetooth headset within 10 ft. of the phone, although
Bluetooth coverage extends to about 30 ft. from the phone.
• Your phone supports the Bluetooth Headset Profile. From your Bluetooth headset, you can
perform these functions:
–
Answer a call
–
End a call
–
Change the headset volume for a call
For more information, see the documentation from your Bluetooth headset manufacturer.
Bluetooth Wireless Headset Performance
The Cisco Unified IP Phone 9951 and 9971 support Bluetooth Class 2 technology when the headsets
support Bluetooth. Bluetooth enables low bandwidth wireless connections within a range of 30 feet
(10 meters). The best performance is in the 3 to 6 feet (1 to 2 meter) range. You can connect up to five
headsets, but only the last one connected is used as the default.
There can be potential interference issues; therefore, it is recommended that you:
• Reduce the proximity of other 802.11b/g devices, Bluetooth devices, microwave ovens, and large
metal objects.
• Use the Cisco Unified IP Phone on the same side of the body as the Bluetooth-enabled headset.
For a Bluetooth wireless headset to work, it does not need to be within direct line-of-sight of the phone,
but some barriers, such as walls or doors, and interference from other electronic devices, could affect
the connection.
To Next Page
Loading...
Need help?
General
