Your Phone
Cisco Unified IP Phone 8961, 9951, and 9971 User Guide for Cisco Unified Communications Manager 7.1(3) (SIP) 47
Power-Save Mode
Depending on how your system administrator set up your phone, the phone display may go into a
power-save mode (the phone screen appears blank and the Select button is lit white).
To turn on the phone display, press any button, touch the blank phone screen, or pick up the handset.
Phone Display Cleaning
Before cleaning the phone display, disable the phone screen by pressing the Select button until you see
the message “Touchscreen Disabled.” The phone screen will re-enable automatically after 60 seconds.
To re-enable the phone screen manually after cleaning, press the Select button until you see the message
“Touchscreen Enabled.”
Caution Use only a soft, dry cloth to wipe the phone display. Do not use any liquids or powders
on the phone because they can contaminate phone components and cause failures.
To Next Page
Loading...
