Cisco Aironet 1200 Series - Setting Up EAP Authentication

4-19
Cisco Aironet 1200 Series Access Point Software Configuration Guide
OL-2159-01
Chapter 4 Security Setup
Setting Up EAP Authentication
Setting Up EAP Authentication
During EAP authentication, the access point relays authentication messages
between the RADIUS server on your network and the authenticating client device.
This section provides instructions for:
• Enabling EAP on the Access Point
• Enabling EAP in Cisco Secure ACS
• Setting up a Repeater Access Point as a LEAP Client
Enabling EAP on the Access Point
You use the Authenticator Configuration page and the AP Radio Data Encryption
page to set up and enable EAP authentication. Figure 4-6 shows the AP Radio
Data Encryption page. Figure 4-8 shows the Authenticator Configuration page.
Figure 4-8 Authenticator Configuration Page