Cisco Aironet 1200 Series - Using Command-Line Diagnostics

9-19
Cisco Aironet 1200 Series Access Point Software Configuration Guide
OL-2159-01
Chapter 9 Diagnostics and Troubleshooting
Using Command-Line Diagnostics
Using Command-Line Diagnostics
You can view diagnostic information about your access point with diagnostic
commands. Enter the commands in the command-line interface (CLI) to display
the information. You can open the CLI with Telnet or with a terminal emulator
through the access point’s serial port.
Table 9-1 lists the access point’s diagnostic commands. Click a command in the
left column to go to a description of that command’s results.
Table 9-1 CLI Diagnostic Commands
Command Information Displayed
:eap_diag1_on authentication progress for client devices
authenticating through the access point
:eap_diag2_on packet contents of each authentication step for client
devices authenticating through the access point
:vxdiag_arpshow the ARP table
:vxdiag_checkstack task stack on the access point
:vxdiag_hostshow remote host list with IP addresses and aliases
:vxdiag_i task list on the access point
:vxdiag_ipstatshow IP statistics
:vxdiag_memshow free and allocated memory on the access point
:vxdiag_muxshow networking protocols installed on the access point
:vxdiag_routeshow current routing information
:vxdiag_tcpstatshow TCP statistics
:vxdiag_udpstatshow UDP statistics