Cisco Aironet 1200 Series - Entering Radio Hardware Information

3-21
Cisco Aironet 1200 Series Access Point Software Configuration Guide
OL-2159-01
Chapter 3 Configuration
Radio Configuration
Service Set ID (SSID)
The SSID is a unique identifier that client devices use to associate with the access
point. The SSID helps client devices distinguish between multiple wireless
networks in the same vicinity. The SSID can be any alphanumeric entry from two
to 32 characters long.
You can also enter this setting on the Express Setup page.
Entering Radio Hardware Information
You use the AP Radio Hardware page to assign settings related to the access
point’s radio hardware. Figure 3-11 shows the AP Radio Hardware page.
Figure 3-11 The AP Radio Hardware Page