Cisco Aironet 1200 Series - Association Table Display Setup

3-59
Cisco Aironet 1200 Series Access Point Software Configuration Guide
OL-2159-01
Chapter 3 Configuration
Association Table Display Setup
Association Table Display Setup
You use the Association Table Filters and the Association Table Advanced pages
to customize the display of information in the access point’s Association Table.
Association Table Filters Page
Figure 3-25 shows the Association Table Filters page.
Figure 3-25 Association Table Filters Page
Follow this link path to reach the Association Table Filters page:
1. On the Summary Status page, click Setup.
2. On the Setup page, click Display Defaults under Associations.
You can also reach the Association Table Filters page through the “additional
display filters” link on the Association Table page. When you reach the page
through the “additional display filters” link, four buttons appear at the bottom of
the page that are different from the standard buttons on management system
pages. The buttons include:
• Apply—Applies your selections to the Association Table and returns you to
the Association Table page.