Cisco Aironet 1200 Series - Console and Telnet Setup

7-5
Cisco Aironet 1200 Series Access Point Software Configuration Guide
OL-2159-01
Chapter 7 Management System Setup
Console and Telnet Setup
Console and Telnet Setup
Use the Console/Telnet Setup page to configure the access point to work with a
terminal emulator or through Telnet. Figure 7-3 shows the Console/Telnet Setup
page.
Figure 7-3 Console/Telnet Setup Page
Follow this link path to reach the Console/Telnet Setup page:
1. On the Summary Status page, click Setup.
2. On the Setup page, click Console/Telnet in the Services section of the page.
Settings on the Console/Telnet Page
The Console/Telnet Setup page contains the following settings:
• Baud Rate—The rate of data transmission expressed in bits per second. Select
a baud rate from 110 to 115,200, depending on the capability of the computer
you use to open the access point management system.
• Parity—An error-detecting process based on the addition of a parity bit to
make the total number of bits Odd or Even. The default setting, None, uses
no parity bit.